Designer Base

Here are a couple of ideas for the designer base.. The first one would be made out of stainless steel/aluminum and tier up the boards. the second two could be made from Richlite or HDPE.. The first idea would be to use 3/8 inch richlite and engrave grooves not all the way through, but most of the way through the board to create base that would hold the boards up like the stands we did for the tradeshows... The second one we could use 1/4 inch Richlite and put feet on it so it holds the stand up a bit.. so basically the boards are resting on the countertop and the stand is just holding them from falling down.. Should still have somewhat of a tiered look just because you'd look at it from above.. the taller you are, the more tiered it would look..

(Click Image To Enlarge)

Stainless Steel/Aluminum Base: Would be made to tier.. I'm not positive on full fabrication 

(Click Image To Enlarge)

Top & Front View of Richlite Idea

(Top) 3/8 inch material with a dado flat bottom

(Bottom) 1/4 inch  material with cut through and rubber feet

(Click Image To Enlarge)

Front View of Richlite Idea

(Top) front view of 3/8 inch dado style

(Bottom) Front view of 1/4 inch cut through